Netgear M7300-24XF (XSM7224S) - ProSAFE 24-port, 10 Gigabit Stackable L2+ Managed Switch ソフトウェアガイド

Using Ezconfig for Switch Setup

Ezconfig is an interactive utility that provides a simplified procedure for setting up the 
following switch parameters:

Switch management IP address

Switch admin user password

Switch name and location

Ezconfig can be entered either in Global Config mode (#) or in Display mode (>). The utility 
displays the following text when you enter the ezconfig command:

(FSM7352S) >ezconfig

NETGEAR EZ Configuration Utility

--------------------------------

Hello and Welcome!

This utility will walk you through assigning the IP address for the 

switch management CPU. It will allow you to save the changes at the 

end. After the session, simply use the newly assigned IP address to 

access the Web GUI using any public domain Web browser.

Admin password not defined. Do you want to change the password? 

(Y/N/Q)

At any point in the setup, you can type Q to abort the program. At 

this point, Ezconfig checks to see if there is any change, and 
prompts you if the changes should be saved.

Changing the Password

As shown in the the following example, you are prompted to change the admin password. For 
security reasons, you should change the default password by typing Y. If you have already 
set the password and do not wish to change it again, type N.

Enter new password:********

Confirm new password:********

Password Changed!

The 'enable' password required for switch configuration through the command 
line interface is currently not configured. Do you wish to change it 
(Y/N/Q)?  y

Enter new password:********

Confirm new password:********

Password Changed!