Netgear M6100 – Campus Edge and SMB Core Chassis Switches ユーザーガイド

Use STP Mode to enable or disable the Spanning Tree Protocol Administrative Mode 

associated with the LAG. The possible values are:

 - Spanning tree is disabled for this LAG.

 - Spanning tree is enabled for this LAG. Enable is the default.

Use Static Mode to select enable or disable from the menu. When the LAG is enabled it 

does not transmit or process received LACPDUs i.e. the member ports do not transmit 

LACPDUs and all the LACPDUs it may receive are dropped. The factory default is Disable.

Use Link Trap to specify whether you want to have a trap sent when link status changes. 

The factory default is Enable, which will cause the trap to be sent.

Use Local Preference Mode to Enable or Disable the LAG interface’s Local Preference 

Mode. The default is Disable.

Click Apply to send the updated configuration to the switch. Configuration changes take 

effect immediately.

Click Cancel to cancel the configuration on the screen and reset the data on the screen to 

the latest value of the switch.

Click Delete to remove the currently selected configured LAG. All ports that were members 

of this LAG are removed from the LAG and included in the default VLAN.

LAG Description

Enter the Description string to be attached to a LAG. 
It can be up to 64 characters in length.

LAG ID

Identification of the LAG.

LAG State

Indicates whether the Link is up or down.

Configured Ports

Indicate the ports that are members of this 
port-channel

Active Ports

Indicates the ports that are actively participating in 
the port-channel.

Use the LAG Membership page to select two or more full-duplex Ethernet links to be 
aggregated together to form a link aggregation group (LAG), which is also known as a 
port-channel. The switch can treat the port-channel as if it were a single link.

To access the LAG Membership page, click Switching







.