Netgear M6100 – Campus Edge and SMB Core Chassis Switches ユーザーガイド

Values configured in the fields above are not saved to the switch. As a 
result, refreshing the page sets these fields to the default values.

- Displays the traceroute IPv4 result after the switch sends a traceroute request to 

the specified IP address or hostname. 

Click Apply to sends a traceroute request to the specified IP address or hostname. The 

results are displayed below the configurable data in the TraceRoute Results area.

Click Cancel to cancel the operation on the screen and reset the data on the screen to the 

latest value of the switch.

Use this screen to tell the switch to send a TraceRoute request to a specified IPv6 address or 
Hostname. You can use this to discover the paths packets take to a remote destination. Once 
you click the Apply button, the switch will send a traceroute and the results will be displayed 
below the configurable data. 

If a reply to the traceroute is received, you will see:

1 a:b:c:d:e:f:g 9869 usec 9775 usec 10584 usec

2 0:0:0:0:0:0:0:0 0 usec * 0 usec * 0 usec *

Hop Count = p Last TTL = q Test attempt = r Test Success = s. 

To display the Traceroute IPv6 page, click Maintenance 





.