Netgear GS728TXS – ProSAFE® Gigabit Stackable Smart Switch with 10G uplink ハードウェアマニュアル
14
GS728TXS/GS752TXS Smart Switch
SFP+ Ports
To enable you to have fiber connections on your network, four SFP+ ports (25 through 28)
accommodate standard 1000M and 10G SFP+ transceiver modules, which are sold
separately.
accommodate standard 1000M and 10G SFP+ transceiver modules, which are sold
separately.
The SFP+ ports can alternatively be used to connect the switch to a stack. Up to two ports
(ports 27 and 28) can be used at a time as stacking ports.
(ports 27 and 28) can be used at a time as stacking ports.
Reset Button
The smart switch has a Reset button on the front panel to allow you to manually reboot the
switch. This action is equivalent to powering the unit off and back on. The last saved
configuration is loaded into the switch as it resets. To use the Reset button, insert a device
such as a straightened paper clip into the opening to press the recessed button. The front
panel LEDs should turn off and light again as the switch performs its power-on self-test
(POST).
switch. This action is equivalent to powering the unit off and back on. The last saved
configuration is loaded into the switch as it resets. To use the Reset button, insert a device
such as a straightened paper clip into the opening to press the recessed button. The front
panel LEDs should turn off and light again as the switch performs its power-on self-test
(POST).
Factory Defaults Button
The smart switch has a Factory Defaults button on the front panel so that you can remove the
current configuration and return the device to its factory settings. When you enable the
Factory Defaults button, all settings including the password, VLAN settings, and port
configurations are removed. To use the Factory Defaults button, insert a device such as a
straightened paper clip into the opening to press the recessed button for over 2 seconds.
current configuration and return the device to its factory settings. When you enable the
Factory Defaults button, all settings including the password, VLAN settings, and port
configurations are removed. To use the Factory Defaults button, insert a device such as a
straightened paper clip into the opening to press the recessed button for over 2 seconds.
Note:
Switches that are part of stack will retain the stacking configuration.
GS752TXS Description
This section describes the smart switch hardware features.
GS752TXS Front Panel and Back Panel Configuration
The GS752TXS has 48 10/100/1000-Mbps copper ports and 4 dedicated
1000 Mbps/10 Gbps SFP+ fiber ports. Up to 2 fiber ports (port 51 and 52) at a time can be
used as stacking ports.
1000 Mbps/10 Gbps SFP+ fiber ports. Up to 2 fiber ports (port 51 and 52) at a time can be
used as stacking ports.
Each port is capable of sensing the line speed and negotiating the duplex mode with the link
partner automatically.
partner automatically.
The following figure illustrates the front panel of the NETGEAR GS752TXS Smart Switch.