Netgear S3300-28X-PoE+ (GS728TXP) - ProSAFE S3300 Smart Switch Series 管理者ガイド

Use the MVR Interface Configuration screen to configure the ports that belong to the MVR 
groups and their roles within the groups. 



Select Switching > MVR > Advanced > MVR Interface Configuration. 

Select the ports to configure.

From the Admin Mode list, select Enable to enable MVR on the selected ports.

From the Type list, specify the MVR type for the selected ports:

Source. The port to which the multicast traffic flows using the multicast VLAN.

Receiver. The port where a listening host is connected to the switch. It can utilize any 
(or no) VLAN, except the multicast VLAN. This implies that the MVR switch performs 
VLAN tag substitution from the multicast VLAN source port to the VLAN tag used by 
the receiver port.

(Optionally for receiver ports) From the Immediate Leave list, enable Immediate Leave 
mode to allow the receiver port to be removed from the multicast group membership 
when an IGMP leave message is received without sending an IGMP query message 
and waiting for the IGMP group membership report.

Click the Apply button. 

Use the MVR Configuration screen to add or remove ports from MVR groups.



Select Switching > MVR > Advanced > MVR Group Membership. 

From the Group IP list, select the IP address of the MVR group to configure.

Click under Group IP to display the ports.

To add a port to the selected MVR group, click the box directly below the port number so 
that a check mark appears in the box.

Click the Apply button.