Netgear GS728TS(B) – ProSAFE 24-Port Gigabit Stackable Smart Switch with 4 SFP uplinks ソフトウェアガイド

MAC Binding Configuration

When an ACL is bound to an interface, all the rules that have been defined are applied to the 
selected interface. Use the MAC Binding Configuration page to assign MAC ACL lists to ACL 
Priorities and Interfaces. 

To display the MAC Binding Configuration page, click Security > ACL > Basic > MAC 
Binding Configuration.

To configure MAC ACL interface bindings:

Select an existing MAC ACL from the ACL ID menu.

The packet filtering direction for ACL is Inbound, which means the MAC ACL rules are 
applied to traffic entering the port.

Specify an optional sequence number to indicate the order of this access list relative to other 
access lists already assigned to this interface and direction. 

A low number indicates high precedence order. If a sequence number is already in use 
for this interface and direction, the specified access list replaces the currently attached 
access list using that sequence number. If the sequence number is not specified by the 
user, a sequence number that is one greater than the highest sequence number currently 
in use for this interface and direction will be used. The valid range is 1–4294967295.

Click the appropriate orange bar to expose the available ports or LAGs. 

To add the selected ACL to a port or LAG, click the box directly below the port or LAG 

number so that a check appears in the box.

To remove the selected ACL from a port or LAG, click the box directly below the port 

or LAG number to clear the selection. A check in the box indicates that the ACL is 
applied to the interface.\