Netgear GS728TS(B) – ProSAFE 24-Port Gigabit Stackable Smart Switch with 4 SFP uplinks ソフトウェアガイド
66
GS728TS, GS728TPS, GS752TS, and GS752TPS Gigabit Smart Switches
The following table describes the Basic Stack Status fields.
Field
Description
Unit ID
The unit ID of the specific switch.
Switch Description
The description for the unit can be configured by the user.
Serial Number
The unique box serial number for this switch.
Uptime
The displays the relative time since the last reboot of the switch.
Preconfigured Model Identifier
This field displays the model type assigned by the device
manufacturer to identify the device.
manufacturer to identify the device.
Plugged-in Model Identifier
This field displays the model type assigned by the device
manufacturer to identify the plugged-in device.
manufacturer to identify the plugged-in device.
Expected Code Type
This field indicates the expected code type on this unit.
Detected Code Version
This field indicates the detected version of code on this unit.
Detected Code Version in Flash
The displays the Release number and version number of the code
stored in flash.
stored in flash.
SFS Last Attempt Status
This displays the status of last tried stack firmware synchronisation.
“None” is the default value if SFS has not been tried.
“None” is the default value if SFS has not been tried.
Stack Port Configuration
By default, the stack ports on each switch are configured for stacking. However, you can use
these ports as standard Ethernet ports. Use the Stack Port configuration page to configure
the mode of the stack ports and to view information about the ports.
these ports as standard Ethernet ports. Use the Stack Port configuration page to configure
the mode of the stack ports and to view information about the ports.
To display the Stack Port Configuration page, click System
Stacking
Advanced
Stack
Port Configuration. A screen similar to the following is displayed.