Netgear XCM8806 - 8800 SERIES 6-SLOT CHASSIS SWITCH ユーザーズマニュアル
50
|
Chapter 2. Getting Started
NETGEAR 8800 User Manual
Traceroute
The
traceroute
command enables you to trace the routed path between the switch and a
destination endstation. The
traceroute
command syntax is:
traceroute {vr <vrid>} {ipv4 <host>} {ipv6 <host>} {ttl <number>} {from <from>} {[port <port>]
| icmp}
Where:
•
vr
is the name of the virtual router.
•
ipv4
/
ipv6
is the transport.
•
from
uses the specified source address in the ICMP packet. If not specified, the address
of the transmitting interface is used.
•
host
is the host of the destination endstation. To use the hostname, you must first
configure DNS.
•
ttl
configures the switch to trace the hops until the time-to-live has been exceeded for
the switch.
•
port
uses the specified UDP port number.
•
icmp
uses ICMP echo messages to trace the routed path.
Displaying Switch Information
To display basic information about the switch, use the following command:
show switch