Netgear XCM8806 - 8800 SERIES 6-SLOT CHASSIS SWITCH ユーザーズマニュアル
842
|
Appendix C. Troubleshooting
NETGEAR 8800 User Manual
Obtaining the Rescue Image from a TFTP Server
To recover the switch, you must enter the Bootloader and issue a series of commands. To
access the Bootloader:
access the Bootloader:
1.
Attach a serial cable to the console port of the MSM.
2.
Attach the other end of the serial cable to a properly configured terminal or terminal
emulator. The terminal settings are:
emulator. The terminal settings are:
•
9600 baud
•
8 data bits
•
1 stop bit
•
no parity
•
XON/OFF flow control enabled
3.
Reboot the MSM and press the spacebar key on the keyboard of the terminal during the
boot up process.
boot up process.
Note:
You must press the spacebar key immediately after a power cycle of the
MSM in order to get into the Bootloader application.
On NETGEAR 8800 series switches, when you see the BootRom banner,
press the spacebar key to get into the Bootloader application.
press the spacebar key to get into the Bootloader application.
As soon as you see the
BootRom ->
prompt, release the spacebar. From here, you can
begin the recovery process.
To obtain the rescue image and recover the switch:
1.
Provide the network information (IP address, netmask, and gateway) for the switch
using the following command:
using the following command:
configip ipaddress <ip-address>[/<netmask>] gateway <gateway-address>
Where the following is true:
•
ip-address
—Specifies the IP address of the switch
•
netmask
—Specifies the netmask of the switch
•
gateway-address
—Specifies the gateway of the switch
2.
Download the XCM8800 image using the following command:
download image <tftp-address> <filename>
Where the following is true:
•
tftp-address
—Specifies the IP address of the TFTP server that contains the
XCM8800 image
•
filename
—Specifies the filename of the XCM8800 image
If you attempt to download a non-rescue image, the switch displays an error message
and returns you to the
and returns you to the
BootRom ->
command prompt.