Netgear M7300-24XF (XSM7224S) - ProSAFE 24-port, 10 Gigabit Stackable L2+ Managed Switch 管理者ガイド

The following example shows how to configure the NETGEAR switch shown in the preceding 
figure to add a double VLAN tag for traffic going from the subnet domain connected to port 
1/0/24. This example assumes there is a Layer 2 switch connecting all these devices in your 
domain. The Layer 2 switch tags the packet going to the NETGEAR switch port 1/0/24. The 
example is shown as CLI commands and as a Web interface procedure. 

CLI: Enable a Double VLAN

Create a VLAN 200.

(Netgear Switch)#vlan database

(Netgear Switch) (Vlan)#vlan 200

(Netgear Switch) (Vlan)#exit

Add interface 1/0/24 to VLAN 200, add pvid 200 to port.

(Netgear Switch) #config 

(Netgear Switch) (Config)#interface 1/0/24 

(Netgear Switch) (Interface 1/0/24)#vlan pvid 200 

(Netgear Switch) (Interface 1/0/24)#vlan participation include 200 

(Netgear Switch) (Interface 1/0/24)#exit

Add interface 1/0/48 to the VLAN 200 in a tagging mode.

(Netgear Switch) (Config)#interface 1/0/48

(Netgear Switch) (Interface 1/0/48)#vlan participation include 200

(Netgear Switch) (Interface 1/0/48)#vlan tagging 200

(Netgear Switch) (Interface 1/0/48)#exit

Select interface 1/0/48 as the provider port.

(Netgear Switch) (Config)#

(Netgear Switch) (Config)#interface 1/0/48

(Netgear Switch) (Interface 1/0/48)#mode dvlan-tunnel

(Netgear Switch) (Interface 1/0/48)#exit

Web Interface: Enable a Double VLAN

Create static VLAN 200: