Netgear M5300-28G3 (GSM7328Sv2h2) - ProSAFE 24+4 Gigabit Ethernet L3 Managed Stackable Switch ソフトウェアガイド

This section describes the commands you use to configure Green Ethernet modes on the 
system. The purpose of the Green Ethernet features is to save power. NETGEAR Managed 
Switch software supports the following three Green Ethernet modes:

Energy-detect mode

Energy-efficient Ethernet (EEE) mode

Green Ethernet commands are supported on M6100 and M7100 
series switches only.

Use this command to enable energy-detect mode on an interface or on a range of interfaces. 
With this mode enabled, when the port link is down, the port automatically powers down for 
short period of time and then wakes up to check link pulses. In energy-detect mode, the port 
can perform auto-negotiation and consume less power when no link partner is present.

.This command is supported on M6100 series switches only.

Use this command to disable energy-detect mode on the interface(s).

Use this command to enable EEE low-power idle mode on an interface or on a range of 
interfaces. The EEE mode enables both send and receive sides of the link to disable some 
functionality for power saving when lightly loaded. The transition to EEE low-power mode 

Default

disabled

Format

green-mode energy-detect

Mode

Interface Config

Format

no green-mode energy-detect

Mode

Interface Config