Netgear M5300-28G3 (GSM7328Sv2h2) - ProSAFE 24+4 Gigabit Ethernet L3 Managed Stackable Switch ソフトウェアガイド

This section describes the commands you use to configure and view Telnet settings. You can 
use Telnet to manage the device from a remote management host.

Use this command to enable Telnet connections to the system and to enable the Telnet 
Server Admin Mode. This command opens the Telnet listening port. 

Use this command to disable Telnet access to the system and to disable the Telnet Server 

Admin Mode. This command closes the Telnet listening port and disconnects all open Telnet 

sessions. 

This command establishes a new outbound Telnet connection to a remote host. The host 
must be a valid IP address or host name. Valid values for port should be a valid decimal 
integer in the range of 0 to 65535, where the default value is 23. If debug is used, the current 
Telnet options enabled is displayed. The optional line parameter sets the outbound Telnet 
operational mode as linemode where, by default, the operational mode is character mode. 
The localecho option enables local echo.

Flow Control 

Whether Hardware Flow-Control is enabled or disabled. Hardware Flow Control is always 
disabled.

Stop Bits

The number of Stop bits per character. The number of Stop bits is always 1.

Parity 

The parity method used on the Serial Port. The Parity Method is always None.

Default

enabled

Format

ip telnet server enable

Mode

Privileged EXEC

Format

no ip telnet server enable

Mode

Privileged EXEC

Format

telnet {ip-address | hostname} port [debug] [line] [localecho]

Modes

Privileged EXEC

User EXEC