Netgear M5300-28G3 (GSM7328Sv2h2) - ProSAFE 24+4 Gigabit Ethernet L3 Managed Stackable Switch ソフトウェアガイド
838
12
12.
Border Gateway Protocol
Commands
This section describes the commands you use to view and configure Border Gateway Protocol
(BGP), which is an exterior gateway routing protocol that you use to route traffic between
autonomous systems. The BGP CLI commands are available in the NETGEAR Managed Switch
software BGP package.
(BGP), which is an exterior gateway routing protocol that you use to route traffic between
autonomous systems. The BGP CLI commands are available in the NETGEAR Managed Switch
software BGP package.
Note:
BGP commands are supported on M6100 series switches only.
The chapter contains the following sections:
•
•
The commands in this chapter are in one of three functional groups:
•
Show commands. Display switch settings, statistics, and other information.
•
Configuration commands. Configure features and options of the switch. For every
configuration command, there is a show command that displays the configuration setting.
configuration command, there is a show command that displays the configuration setting.
•
Clear commands. Reset part of the protocol state.