Netgear M5300-28G3 (GSM7328Sv2h2) - ProSAFE 24+4 Gigabit Ethernet L3 Managed Stackable Switch 管理者ガイド
MLAGs
96
Managed Switches
3.
Configure the destination and source IP addresses of the peer on switch S.
(Switch S) (Config)#vpc domain 1
(Switch S) (Config-VPC 1)#peer-keepalive destination 192.168.105.1 source
192.168.104.1
192.168.104.1
4.
Check the status of the DCPDP peer.
Web Interface: Configure the DCPDP on MLAG Interfaces
1.
Configure the DCPDP on switch P.
For information about switch P, see
figure.
a. Select Routing > VRRP > Basic > VRRP Configuration.
A screen similar to the following displays.
b. Under Peer Detection, next to Peer Detection Mode, select the Enable radio button.
c. Enter the following information in the Peer Detection section:
•
In the Peer IP Address field, enter 192.168.104.1.
•
In the Source IP Address field, select 192.168.105.1.
•
In the UDP Port field, enter 50000.
(M7100-24X) #show vpc peer-keepalive
Peer IP address................................ 192.168.105.1
Source IP address.............................. 192.168.104.1
UDP port....................................... 50000
Peer detection................................. Enabled
Peer detection operational status.............. Up
Peer is detected............................... TRUE