Netgear M5300-28G3 (GSM7328Sv2h2) - ProSAFE 24+4 Gigabit Ethernet L3 Managed Stackable Switch 管理者ガイド
128
|
Chapter 9. VRRP
ProSafe Managed Switch
a. Select Routing > VRRP > Advanced > VRRP Configuration. A screen similar to the
following displays.
b. Under Global Configuration, next to the Admin Mode, select Enable radio button.
c. Enter the following information in the VRRP Configuration:
•
In the VRID (1 to 255) field, enter 20.
•
In the Interface field, select 1/0/2.
•
In the Primary IP Address field, enter 192.150.2.1.
•
In the Mode field, select Active.
d. Click Apply to save the settings.
VRRP on a Backup Router
The example is shown as CLI commands and as a Web interface procedure.
CLI: Configure VRRP on a Backup Router
1.
Enable routing for the switch. IP forwarding will then be enabled by default.
2.
Configure the IP addresses and subnet masks for the port that will participate in the protocol.
(Netgear Switch) #config
(Netgear Switch) (Config)#ip routing
(Netgear Switch) (Config)#interface 1/0/4
(Netgear Switch) (Interface 1/0/4)#routing
(Netgear Switch) (Interface 1/0/4)#ip address 192.150.4.1 255.255.0.0
(Netgear Switch) (Interface 1/0/4)#exit