Netgear M5300-28G (GSM7228S) - ProSAFE 24-port Gigabit L2+ Managed Stackable Switch ソフトウェアガイド
IPv6 Commands
983
M5300, M6100, and M7100 Series ProSAFE Managed Switches
no trapflags
Use this command to revert to the default reference bandwidth.
•
To disable the individual flag, enter the no trapflags group name followed by a
particular flag.
particular flag.
•
To disable all the flags in that group, enter no trapflags group name followed by
all
all
.
•
To disable all the flags, enter the command as no trapflags all.
OSPFv3 Interface Commands
ipv6 ospf area
This command sets the OSPF area to which the specified router interface or range of
interfaces belongs. It also enables OSPF on the specified router interface or range of
interfaces. The area-id is a 32-bit integer, formatted as a 4-digit dotted-decimal number or
a decimal value in the range of 0-4294967295. The area-id uniquely identifies the area to
which the interface connects. Assigning an area ID for an area that does not yet exist, causes
the area to be created with default values.
interfaces belongs. It also enables OSPF on the specified router interface or range of
interfaces. The area-id is a 32-bit integer, formatted as a 4-digit dotted-decimal number or
a decimal value in the range of 0-4294967295. The area-id uniquely identifies the area to
which the interface connects. Assigning an area ID for an area that does not yet exist, causes
the area to be created with default values.
ipv6 ospf cost
This command configures the cost on an OSPF interface or range of interfaces. The cost
parameter has is in the range of 1 to 65535.
parameter has is in the range of 1 to 65535.
Default
disabled
Format
trapflags {all | errors {all | authentication-failure | bad-packet |
config-error | virt-authentication-failure | virt-bad-packet |
virt-config-error} | lsa {all | lsa-maxage | lsa-originate} | overflow {all |
lsdb-overflow | lsdb-approaching-overflow} | retransmit {all | packets |
virt-packets} | state-change {all | if-state-change | neighbor-state-change |
virtif-state-change | virtneighbor-state-change}}
Mode
Router OSPFv3 Config
Format
no trapflags {all | errors {all | authentication-failure | bad-packet |
config-error | virt-authentication-failure | virt-bad-packet |
virt-config-error} | lsa {all | lsa-maxage | lsa-originate} | overflow {all |
lsdb-overflow | lsdb-approaching-overflow} | retransmit {all | packets |
virt-packets} | state-change {all | if-state-change | neighbor-state-change |
virtif-state-change | virtneighbor-state-change}}
Mode
Router OSPFv3 Config
Format
ipv6 ospf area area-id
Mode
Interface Config