Netgear M5300-28G (GSM7228S) - ProSAFE 24-port Gigabit L2+ Managed Stackable Switch ソフトウェアガイド

The default admin user name is admin and the default admin password is blank, that is, 
do not enter a password.

Click the Login button. 

The web management interface menu displays.

Select Routing > OSPFv3 > Basic > OSPFv3 Configuration. 

Select the Admin Mode Disable or Enable radio button.

If you select Enable, OSPFv3 is activated for the switch. By default, OSPFv3 is enabled. 
You must configure a router ID before OSPFv3 can become operational. This can also be 
done by issuing the CLI command config router id in IPv6 router OSPF mode. For more 
information, see 

325.

Once OSPFv3 is initialized on the router, it remains initialized until the 
router is reset.

Enter the Router ID as a 32-bit integer in dotted-decimal format that uniquely identifies the 

router within the autonomous system (AS). 

To change the router ID, you must first disable OSPFv3. After you set the new router ID, 
you must reenable OSPFv3 for the change to take effect. The default value is 0.0.0.0, 
although this is not a valid router ID.

Click the Apply button.

The updated configuration is sent to the switch. Configuration changes take effect 
immediately.

Prepare your computer with a static IP address in the 169.254.100.0 subnet, for 

example, 169.254.100.201.

Connect an Ethernet cable from an Ethernet port on your computer to an Ethernet port on 

the switch.

Launch a web browser.

Enter the IP address of the switch in the web browser address field.

The default IP address of the switch is 169.254.100.100. 

The Login screen displays.

Enter the user name and password.