Netgear M5300-28G (GSM7228S) - ProSAFE 24-port Gigabit L2+ Managed Stackable Switch 管理者ガイド
186
|
Chapter 11. CoS Queuing
ProSafe Managed Switch
CoS Queue Configuration
CoS queue configuration involves port egress queue configuration and drop precedence
configuration (per queue). The design of these on a per-queue, pe- drop precedence basis
allows you to create the service characteristics that you want for different types of traffic.
configuration (per queue). The design of these on a per-queue, pe- drop precedence basis
allows you to create the service characteristics that you want for different types of traffic.
Port egress queue configuration:
•
Scheduler type, strict vs. weighted
•
Minimum guaranteed bandwidth
•
Maximum allowed bandwidth per-queue shaping
•
Queue management type, tail drop vs. WRED
Drop precedence configuration (per queue):
•
WRED parameters
-
Minimum threshold
-
Maximum threshold
-
Drop probability
-
Scale factor
•
Tail drop parameters, threshold
Per-interface basis:
•
Queue management type, rail Drop vs. WRED
Only if per-queue configuration is not supported
•
WRED decay exponent
•
Traffic shaping for an entire interface
Show classofservice Trust
The example is shown as CLI commands and as a Web interface procedure.
CLI: Show classofservice Trust
To use the CLI to show CoS trust mode, use these commands:
(Netgear Switch) #show classofservice trust?
<cr>
Press Enter to execute the command.
(Netgear Switch) #show classofservice trust
Class of Service Trust Mode: Dot1P