Netgear M5300-28G (GSM7228S) - ProSAFE 24-port Gigabit L2+ Managed Stackable Switch 管理者ガイド
Chapter 16. SNTP
|
309
ProSafe Managed Switch
Configure SNTP
The example is shown as CLI commands and as a Web interface procedure.
CLI: Configure SNTP
NETGEAR switches do not have a built-in real-time clock. However, it is possible to use
SNTP to get the time from a public SNTP/NTP server over the Internet. You may need
permission from those public time servers. The following steps configure SNTP on the
switch:
SNTP to get the time from a public SNTP/NTP server over the Internet. You may need
permission from those public time servers. The following steps configure SNTP on the
switch:
1.
Configure the SNTP server IP address. The IP address can be either from the public
NTP server or your own. You can search the Internet to locate the public server. The
servers available could be listed in domain-name format instead of address format. In
that case, use the ping command on the PC to find the server’s IP address. The
following example configures the SNTP server IP address to 208.14.208.19.
NTP server or your own. You can search the Internet to locate the public server. The
servers available could be listed in domain-name format instead of address format. In
that case, use the ping command on the PC to find the server’s IP address. The
following example configures the SNTP server IP address to 208.14.208.19.
2.
After configuring the IP address, enable SNTP client mode. The client mode can be either
broadcast mode or unicast mode. If the NTP server is not your own, you must use unicast
mode.
mode.
3.
Once SNTP client mode is enabled, the client waits for the polling interval to send the query
to the server. The default value is approximately 1 minute. After this period, issue the show
to the server. The default value is approximately 1 minute. After this period, issue the show
(Netgear Switch) (Config)#sntp server 208.14.208.19
(Netgear Switch) (Config)#sntp client mode unicast