Netgear M5300-28G (GSM7228S) - ProSAFE 24-port Gigabit L2+ Managed Stackable Switch 管理者ガイド

Web Interface: Enableg RIP on the Switch

Select Routing > RIP > Basic > RIP Configuration. A screen similar to the following 
displays.

For RIP Admin Mode, select Enable radio button.

Click Apply to save the setting.

RIP for Ports 1/0/2 and 1/0/3

The example is shown as CLI commands and as a Web interface procedure.

CLI: Enable RIP for Ports 1/0/2 and 1/0/3

This command sequence enables RIP for ports 1/0/2 and 1/0/3. Authentication defaults to 
none, and no default route entry is created. The commands specify that both ports receive 
both RIPv1 and RIPv2 frames, but send only RIPv2-formatted frames.

(Netgear Switch) #config

(Netgear Switch) (Config)#interface 1/0/2

(Netgear Switch) (Interface 1/0/2)#ip rip

(Netgear Switch) (Interface 1/0/2)#ip rip receive version both

(Netgear Switch) (Interface 1/0/2)#ip rip send version rip2

(Netgear Switch) (Interface 1/0/2)#exit

(Netgear Switch) (Config)#interface 1/0/3

(Netgear Switch) (Interface 1/0/3)#ip rip

(Netgear Switch) (Interface 1/0/3)#ip rip receive version both

(Netgear Switch) (Interface 1/0/3)#ip rip send version rip2

(Netgear Switch) (Interface 1/0/3)#exit

(Netgear Switch) (Config)#exit