Netgear M4300-48X (XSM4348CS) - Stackable Switches with Full PoE+ Provisioning ソフトウェアガイド
Management Commands
134
M4200 and M4300 Series ProSAFE Managed Switches
RADIUS Commands
This section describes the commands you use to configure the switch to use a Remote
Authentication Dial-In User Service (RADIUS) server on your network for authentication and
accounting.
aaa server radius dynamic-author
This command enables Change of Authorization (CoA) functionality and lets you configure
the switch from the dynamic authorization local server configuration mode.
the switch from the dynamic authorization local server configuration mode.
no aaa server radius dynamic-author
This command disables Change of Authorization (CoA) functionality.
auth-type
This command specifies the type of authorization that the switch uses for RADIUS clients.
The client must match the configured attributes for authorization.
The client must match the configured attributes for authorization.
BGP4 Traps
Can be enabled or disabled. The factory default is disabled. Indicates whether BGP4 traps are sent.
(This field appears only on systems with the BGPv4 software package installed.)
(This field appears only on systems with the BGPv4 software package installed.)
DVMRP Traps
Can be enabled or disabled. The factory default is disabled. Indicates whether DVMRP traps are
sent.
sent.
OSPFv2 Traps
Can be enabled or disabled. The factory default is disabled. Indicates whether OSPF traps are sent.
If any of the OSPF trap flags are not enabled, then the command displays
If any of the OSPF trap flags are not enabled, then the command displays
disabled. Otherwise, the
command shows all the enabled OSPF traps’ information.
OSPFv3 Traps
Can be enabled or disabled. The factory default is disabled. Indicates whether OSPF traps are sent.
If any of the OSPFv3 trap flags are not enabled, then the command displays
If any of the OSPFv3 trap flags are not enabled, then the command displays
disabled. Otherwise,
the command shows all the enabled OSPFv3 traps’ information.
PIM Traps
Can be enabled or disabled. The factory default is disabled. Indicates whether PIM traps are sent.
Format
aaa server radius dynamic-author
Mode
Global Config
Format
no aaa server radius dynamic-author
Mode
Global Config
Default
all
Format
auth-type {any | all | session-key}
Mode
Dynamic Authorization
Term
Definition