Netgear M4300-24X (XSM4324CS) - Stackable Switches with Full PoE+ Provisioning ユーザーズマニュアル
Configure System Information
64
M4200 and M4300 Series ProSAFE Managed Switches Web Management User Manual
Configure an SNTP Server
SNTP assures accurate network device clock time synchronization up to the millisecond.
Time synchronization is performed by a network SNTP server. The switch software operates
only as an SNTP client and cannot provide time services to other systems.
Time synchronization is performed by a network SNTP server. The switch software operates
only as an SNTP client and cannot provide time services to other systems.
Time sources are established by stratums. Stratums define the accuracy of the reference
clock. The higher the stratum (where zero is the highest), the more accurate the clock. The
device receives time from Stratum 1 and above since it is itself a Stratum 2 device.
clock. The higher the stratum (where zero is the highest), the more accurate the clock. The
device receives time from Stratum 1 and above since it is itself a Stratum 2 device.
The following is an example of stratums:
•
Stratum 0
. A real-time clock is used as the time source, for example, a GPS system.
•
Stratum 1
. A server that is directly linked to a Stratum 0 time source is used. Stratum 1
time servers provide primary network time standards.
•
Stratum 2
. The time source is distanced from the Stratum 1 server over a network path.
For example, a Stratum 2 server receives the time over a network link, through NTP, from
a Stratum 1 server.
a Stratum 1 server.
Information received from SNTP servers is evaluated based on the time level and server
type.
type.
SNTP time definitions are assessed and determined by the following time levels:
•
T1
. Time that the original request was sent by the client.
•
T2
. Time that the original request was received by the server.
•
T3
. Time that the server sent a reply.
•
T4
. Time that the client received the server's reply.
The device can poll unicast server types for the server time.
Polling for unicast information is used for polling a server for which the IP address is known.
SNTP servers that were configured on the device are the only ones that are polled for
synchronization information. T1 through T4 are used to determine server time. This is the
preferred method for synchronizing device time because it is the most secure method. If this
method is selected, SNTP information is accepted only from SNTP servers defined on the
device using the SNTP Server Configuration page.
SNTP servers that were configured on the device are the only ones that are polled for
synchronization information. T1 through T4 are used to determine server time. This is the
preferred method for synchronizing device time because it is the most secure method. If this
method is selected, SNTP information is accepted only from SNTP servers defined on the
device using the SNTP Server Configuration page.
The device retrieves synchronization information, either by actively requesting information or
at every poll interval.
at every poll interval.
You can view and modify information for adding and modifying Simple Network Time Protocol
SNTP servers.
SNTP servers.
To configure the SNTP server settings:
1.
Launch a web browser.
2.
Enter http://<ipaddress> in the web browser address field.
The login window opens.
3.
Enter the user name and password.