Netgear M4300-24X (XSM4324CS) - Stackable Switches with Full PoE+ Provisioning ソフトウェアガイド

This section describes the commands you use to configure the switch to use a Remote 

Authentication Dial-In User Service (RADIUS) server on your network for authentication and 

accounting.

This command enables Change of Authorization (CoA) functionality and lets you configure 
the switch from the dynamic authorization local server configuration mode.

This command disables Change of Authorization (CoA) functionality.

This command specifies the type of authorization that the switch uses for RADIUS clients. 
The client must match the configured attributes for authorization.

BGP4 Traps

Can be enabled or disabled. The factory default is disabled. Indicates whether BGP4 traps are sent. 
(This field appears only on systems with the BGPv4 software package installed.)

DVMRP Traps

Can be enabled or disabled. The factory default is disabled. Indicates whether DVMRP traps are 
sent. 

OSPFv2 Traps

Can be enabled or disabled. The factory default is disabled. Indicates whether OSPF traps are sent. 
If any of the OSPF trap flags are not enabled, then the command displays 

disabled. Otherwise, the 

command shows all the enabled OSPF traps’ information.

OSPFv3 Traps

Can be enabled or disabled. The factory default is disabled. Indicates whether OSPF traps are sent. 
If any of the OSPFv3 trap flags are not enabled, then the command displays 

disabled. Otherwise, 

the command shows all the enabled OSPFv3 traps’ information.

PIM Traps

Can be enabled or disabled. The factory default is disabled. Indicates whether PIM traps are sent.

Format

aaa server radius dynamic-author

Mode

Global Config

Format

no aaa server radius dynamic-author

Mode

Global Config

Default

all

Format

auth-type {any | all | session-key}

Mode

Dynamic Authorization