Netgear M4300-24X (XSM4324CS) - Stackable Switches with Full PoE+ Provisioning ソフトウェアガイド
Software Modules
17
M4200 and M4300 Series ProSAFE Managed Switches
Command Modes
The CLI groups commands into modes according to the command function. Each of the
command modes supports specific commands. The commands in one mode are not
available until you switch to that particular mode, with the exception of the User EXEC mode
commands. You can execute the User EXEC mode commands in the Privileged EXEC
mode.
command modes supports specific commands. The commands in one mode are not
available until you switch to that particular mode, with the exception of the User EXEC mode
commands. You can execute the User EXEC mode commands in the Privileged EXEC
mode.
The command prompt changes in each command mode to help you identify the current
mode. The following table describes the command modes and the prompts visible in that
mode.
mode. The following table describes the command modes and the prompts visible in that
mode.
Note:
The command modes available on your switch depend on the software
modules that are installed. For example, a switch that does not support
BGPv4 does not have the BGPv4 Router Command Mode.
modules that are installed. For example, a switch that does not support
BGPv4 does not have the BGPv4 Router Command Mode.
Table 5. CLI Command Modes
Command Mode
Prompt
Mode Description
User EXEC
Switch>
Contains a limited set of commands to view
basic system information.
basic system information.
Privileged EXEC
Switch#
Allows you to issue any EXEC command,
enter the VLAN mode, or enter the Global
Configuration mode.
Configuration mode.
Global Config
Switch (Config)#
Groups general setup commands and
permits you to make modifications to the
running configuration.
permits you to make modifications to the
running configuration.
VLAN Config
Switch (Vlan)#
Groups all the VLAN commands.
Interface Config
Switch (Interface
unit/slot/port)#
Manages the operation of an interface and
provides access to the router interface
configuration commands.
provides access to the router interface
configuration commands.
Use this mode to set up a physical port for a
specific logical connection operation.
specific logical connection operation.
Switch (Interface Loopback id)#
Switch (Interface Tunnel id)#
Switch (Interface unit/slot/port
(startrange)-unit/slot/port
(endrange)#
Use this mode to manage the operation of a
range of interfaces. For example the prompt
may display as follows:
range of interfaces. For example the prompt
may display as follows:
Switch (Interface 1/0/1-1/0/4) #
Switch (Interface lag
lag-intf-num)#
Enters LAG Interface configuration mode for
the specified LAG.
the specified LAG.
Switch (Interface vlan vlan-id)#
Enters VLAN routing interface configuration
mode for the specified VLAN ID.
mode for the specified VLAN ID.