Netgear M4300-24X (XSM4324CS) - Stackable Switches with Full PoE+ Provisioning ソフトウェアガイド

This section describes the commands you use to view and configure port settings. 

This command gives you access to the Interface Config mode, which allows you to enable or 
modify the operation of an interface (port). 

You can also specify a range of ports to configure at the same time by specifying the starting 
unit/slot/port

 and ending unit/slot/port, separated by a hyphen.

The following example enters Interface Config mode for port 1/0/1:

(NETGEAR Switch) #configure

(NETGEAR Switch) (config)#interface 1/0/1

(NETGEAR Switch) (interface 1/0/1)#

The following example enters Interface Config mode for ports 1/0/1 through 1/0/4:

(NETGEAR Switch) #configure

(NETGEAR Switch) (config)#interface 1/0/1-1/0/4

(NETGEAR Switch) (interface 1/0/1-1/0/4)#

This command enables automatic negotiation on a port or range of ports.

This command disables automatic negotiation on a port.Automatic sensing is disabled when 
automatic negotiation is disabled.

Format

interface {unit/slot/port | unit/slot/port-unit/slot/port}

Mode

Global Config

Default

enabled

Format

auto-negotiate

Mode

Interface Config

Format

no auto-negotiate

Mode

Interface Config