Netgear M4300-24X (XSM4324CS) - Stackable Switches with Full PoE+ Provisioning ソフトウェアガイド
Switching Commands
438
M4200 and M4300 Series ProSAFE Managed Switches
GVRP Commands
This section describes the commands you use to configure and view GARP VLAN
Registration Protocol (GVRP) information. GVRP-enabled switches exchange VLAN
configuration information, which allows GVRP to provide dynamic VLAN creation on trunk
ports and automatic VLAN pruning.
Registration Protocol (GVRP) information. GVRP-enabled switches exchange VLAN
configuration information, which allows GVRP to provide dynamic VLAN creation on trunk
ports and automatic VLAN pruning.
Note:
If GVRP is disabled, the system does not forward GVRP messages.
set gvrp adminmode
This command enables GVRP on the system.
no set gvrp adminmode
This command disables GVRP.
set gvrp interfacemode
This command enables GVRP on a single port (Interface Config mode), a range of ports
(Interface Range mode), or all ports (Global Config mode).
(Interface Range mode), or all ports (Global Config mode).
Term
Definition
GMRP Admin
Mode
Mode
The administrative mode of GARP Multicast Registration Protocol (GMRP) for the system.
GVRP Admin Mode The administrative mode of GARP VLAN Registration Protocol (GVRP) for the system.
Default
disabled
Format
set gvrp adminmode
Mode
Privileged EXEC
Format
no set gvrp adminmode
Mode
Privileged EXEC
Default
disabled
Format
set gvrp interfacemode
Mode
Interface Config
Interface Range
Global Config