Netgear M4300-24X (XSM4324CS) - Stackable Switches with Full PoE+ Provisioning ソフトウェアガイド
Routing Commands
728
M4200 and M4300 Series ProSAFE Managed Switches
clear ip ospf stub-router
Use the clear ip ospf stub-router command in Privileged EXEC mode to force OSPF to exit
stub router mode when it has automatically entered stub router mode because of a resource
limitation. OSPF only exits stub router mode if it entered stub router mode because of a
resource limitation or it if is in stub router mode at startup. If OSPF is configured to function
permanently in stub router mode, the command does not take effect.
stub router mode when it has automatically entered stub router mode because of a resource
limitation. OSPF only exits stub router mode if it entered stub router mode because of a
resource limitation or it if is in stub router mode at startup. If OSPF is configured to function
permanently in stub router mode, the command does not take effect.
OSPF Show Commands
show ip ospf
This command displays information relevant to the OSPF router.
Note:
Some of the information below displays only if you enable OSPF and
configure certain features.
configure certain features.
Format
clear ip ospf stub-router
Mode
Privileged EXEC
Format
show ip ospf
Mode
Privileged EXEC
Term
Definition
Router ID
A 32-bit integer in dotted decimal format identifying the router, about which information is displayed.
This is a configured value.
OSPF Admin Mode Shows whether the administrative mode of OSPF in the router is enabled or disabled. This is a
configured value.
RFC 1583
Compatibility
Compatibility
Indicates whether 1583 compatibility is enabled or disabled. This is a configured value.
External LSDB
Limit
Limit
The maximum number of nondefault AS-external-LSA (link state advertisement) entries that can be
stored in the link-state database.
stored in the link-state database.
Exit Overflow
Interval
Interval
The number of seconds that, after entering overflow state, a router will attempt to leave overflow
state.
state.
Spf Delay Time
The number of seconds between two subsequent changes of LSAs, during which time the routing
table calculation is delayed.
table calculation is delayed.
Spf Hold Time
The number of seconds between two consecutive spf calculations.
Flood Pacing
Interval
Interval
The average time, in milliseconds, between LS Update packet transmissions on an interface. This is
the value configured with the command
the value configured with the command