Netgear FVS318N – Prosafe Wireless N VPN Firewall 参照マニュアル

Firewall rules are used to block or allow specific traffic passing through from one side to the 
other. You can configure up to 800 firewall rules on the wireless VPN firewall (see the 
following table). Inbound rules (WAN to LAN) restrict access by outsiders to private 
resources, selectively allowing only specific outside users to access specific resources. 
Outbound rules (LAN to WAN) determine what outside resources local users can have 
access to.

A firewall has two default rules, one for inbound traffic and one for outbound. The default 

rules of the wireless VPN firewall are:

Inbound. Block all access from outside except responses to requests from the LAN side.

Outbound. Allow all access from the LAN side to the outside.

The firewall rules for blocking and allowing traffic on the wireless VPN firewall can be applied 
to LAN WAN traffic, DMZ WAN traffic, and LAN DMZ traffic.

The rules to block or allow traffic are based on the traffic’s category of service:

Outbound rules (service blocking). Outbound traffic is allowed unless you configure 
the firewall to block specific or all outbound traffic.

Inbound rules (port forwarding). Inbound traffic is blocked unless the traffic is in 
response to a request from the LAN side. You can configure the firewall to allow specific 
or all inbound traffic.

Customized services. You can add additional services to the list of services in the 
factory defaults list. You can then define rules for these added services to either allow or 
block that traffic (see 

Quality of Service (QoS) priorities. Each service has its own native priority that impacts 
its quality of performance and tolerance for jitter or delays. You can change the QoS 
priority, which changes the traffic mix through the system (see 

LAN WAN

300

300

600

DMZ WAN

50

50

100

LAN DMZ

50

50

100

Total Rules

400

400

800