Netgear FVS318N – Prosafe Wireless N VPN Firewall 参照マニュアル
Virtual Private Networking Using IPSec and L2TP Connections
265
ProSAFE Wireless-N 8-Port Gigabit VPN Firewall FVS318N
is established, the L2TP user can connect to an L2TP client that is located behind the
wireless VPN firewall.
wireless VPN firewall.
Note:
IPSec VPN provides stronger authentication and encryption than
L2TP. (Packets that traverse the L2TP tunnel are not encapsulated
by IPSec.)
L2TP. (Packets that traverse the L2TP tunnel are not encapsulated
by IPSec.)
You need to enable the L2TP server on the wireless VPN firewall, specify an L2TP server
address pool, and create L2TP user accounts. (L2TP users are authenticated through local
authentication with geardomain.) For information about how to create L2TP user accounts,
see
address pool, and create L2TP user accounts. (L2TP users are authenticated through local
authentication with geardomain.) For information about how to create L2TP user accounts,
see
To enable the L2TP server and configure the L2TP server pool:
1.
Select VPN > L2TP Server. The L2TP Server screen displays. (The following figure
contains an example.)
contains an example.)
Figure 161.
2.
To enable the L2TP server, select the Enable check box.
3.
Enter the settings as described in the following table:
Table 64. L2TP Server screen settings
Setting
Description
L2TP Server Configuration
Starting IP Address
The first IP address of the pool. This address is used for distribution to the wireless
VPN firewall.
VPN firewall.
Ending IP Address
The last IP address of the pool. A maximum of 26 contiguous addresses is
supported. (The first address of the pool cannot be assigned to a user.)
supported. (The first address of the pool cannot be assigned to a user.)
Idle Timeout
The period after which an idle user is automatically logged out of the L2TP server.
The default idle time-out period is 10 minutes.
The default idle time-out period is 10 minutes.