Netgear FVS318v3 – Cable/DSL ProSafe VPN Firewall with 8-Port Switch 参照マニュアル

8-1

This chapter gives information about troubleshooting your ProSafe VPN Firewall . After each 
problem description, instructions are provided to help you diagnose and solve the problem.

After you turn on power to the firewall, the following sequence of events should occur:

1. When power is first applied, verify that the PWR LED is on.

2. After approximately 30 seconds, verify that:

a. The TEST LED is not lit.

b. The LAN port LEDs are lit for any local ports that are connected.

c. The Internet port LED is lit.

If a port’s LED is lit, a link has been established to the connected device. If a LAN port is 
connected to a 100 Mbps device, verify that the port’s LED is green. If the port is 10 Mbps, the 
LED will be green.

If any of these conditions does not occur, refer to the appropriate following section.

If the Power and other LEDs are off when your firewall is turned on:

•

Make sure that the power cord is properly connected to your firewall and that the power 
supply adapter is properly connected to a functioning power outlet. 

•

Check that you are using the 12 V DC power adapter supplied by NETGEAR for this product.

If the error persists, you have a hardware problem and should contact technical support.

When the firewall is turned on, the LEDs turn on briefly and then turn off. If all the LEDs stay on, 
there is a fault within the firewall.