Netgear FVS318Gv2 – ProSAFE VPN Firewall Series ユーザーズマニュアル
Configure VPN Tunnels
30
NETGEAR ProSAFE VPN Client
a. In the Interface menu, leave Any selected if the IP address changes (when it is
received dynamically from an ISP or router).
You can enter the IP address of the network interface of the computer through which
the VPN connection is established. If you select an IP address that does not exist on
the computer, Any is used automatically.
the VPN connection is established. If you select an IP address that does not exist on
the computer, Any is used automatically.
b. In the Remote Gateway field, type the remote IP address or the DNS name of the
VPN gateway.
For example, type myrouter.dyn.com or 10.200.13.18.
6.
To specify a preshared key, do the following:
a. Select the Preshared Key radio button.
b. Enter the preshared key that you already specified in the VPN gateway in the
Preshared Key field and in the Confirm field.
7.
To specify a X509 certificate, do the following:
a. Click the Certificate tab.
The Certificate page displays the certificate source. You can use a PEM file,
PKCS#21 file, smart card, or token, or a certificate from the Personal Certificate
Store. Specify only one certificate per tunnel.
PKCS#21 file, smart card, or token, or a certificate from the Personal Certificate
Store. Specify only one certificate per tunnel.
b. Select the certificate.
57.
c. Click the Authentication tab.
8.
In the Encryption menu, select the encryption algorithm that is used during the
authentication phase.
authentication phase.
For a typical NETGEAR VPN gateway, select 3DES.
9.
In the Authentication menu, select the authentication algorithm that is used during the
authentication phase.
authentication phase.
For a typical NETGEAR VPN gateway, select SHA1.
10.
In the Key Group field, select the Diffie-Hellman key length that is used during the
authentication phase.
authentication phase.
For a typical NETGEAR VPN gateway, select DH2 (1024). On NETGEAR routers, this
key group is referred to as Diffie-Hellman Group 2 (1024 bit).
key group is referred to as Diffie-Hellman Group 2 (1024 bit).
11.
Select Configuration > Save or press Ctrl + S.
Your settings are saved.
Configure Advanced Authentication Settings
For IKE authentication settings, the advanced configuration settings apply to all its associated
IPSec policy settings.
IPSec policy settings.