Netgear FVS318Gv2 – ProSAFE VPN Firewall Series 参照マニュアル
Virtual Private Networking Using IPSec and L2TP Connections
216
NETGEAR ProSAFE VPN Firewall FVS318G v2
5.
Click the Apply button.
Your changes are saved.
6.
Configure a VPN policy on the remote gateway that allows connection to the VPN firewall.
7.
Activate the IPSec VPN connection:
a. Select VPN > Connection Status.
a. Select VPN > Connection Status.
b. Locate the policy in the table, and click the Connect table button.
The IPSec VPN connection becomes active.
Secure Connection Remote Accessibility
What is the remote LAN IP
Address?
Address?
Enter the LAN IPv4 address of the remote gateway.
Note:
The remote LAN IPv4 address must be in a different subnet from the
local LAN IP address. For example, if the local subnet is 192.168.1.x, the
remote subnet could be 192.168.10.x but could not be 192.168.1.x. If this
information is incorrect, the tunnel fails to connect.
remote subnet could be 192.168.10.x but could not be 192.168.1.x. If this
information is incorrect, the tunnel fails to connect.
What is the remote LAN
Subnet Mask?
Subnet Mask?
Enter the LAN subnet mask for the remote gateway.
a. Both local and remote endpoints must be defined as either FQDNs or IP addresses. A combination of an IP address and
an FQDN is not supported.
Table 41. IPSec VPN Wizard settings for an IPv4 gateway-to-gateway tunnel (continued)
Setting
Description