Netgear GSM7248v2 - ProSAFE 48 Port Layer 2 Gigabit L2 Ethernet Switch 管理者ガイド

MLD is a protocol used by IPv6 multicast routers to discover the presence of multicast 
listeners (nodes configured to receive IPv6 multicast packets) on its directly attached links 
and to discover which multicast packets are of interest to neighboring nodes. MLD is derived 
from IGMP; MLD version 1 (MLDv1) is equivalent to IGMPv2, and MLD version 2 (MLDv2) is 
equivalent to IGMPv3. MLD is a subprotocol of Internet Control Message Protocol version 6 
(ICMPv6), and MLD messages are a subset of ICMPv6 messages, identified in IPv6 packets 
by a preceding Next Header value of 58.

The switch can snoop on both MLDv1 and MLDv2 protocol packets and bridge IPv6 multicast 
data based on destination IPv6 multicast MAC addresses. The switch can be configured to 
perform MLD snooping and IGMP snooping simultaneously.

CLI: Configure MLD Snooping

Enter the following commands.

(Netgear Switch) #vlan da

(Netgear Switch) (Vlan)#vlan 300

(Netgear Switch) (Vlan)#exit

(Netgear Switch) #config

(Netgear Switch) (Config)#interface 1/0/1

(Netgear Switch) (Interface 1/0/1)#vlan participation include 300

(Netgear Switch) (Interface 1/0/1)#vlan pvid 300

(Netgear Switch) (Interface 1/0/1)#exit

(Netgear Switch) (Config)#interface 1/0/24

(Netgear Switch) (Interface 1/0/24)#vlan participation include 300

(Netgear Switch) (Interface 1/0/24)#vlan pvid 300

(Netgear Switch) (Interface 1/0/24)#exit

(Netgear Switch) (Config)#exit

(Netgear Switch) (Config)#set mld

(Netgear Switch) (Config)#exit

(Netgear Switch) #vlan database

(Netgear Switch) (Vlan)#set mld 300

(Netgear Switch) (Vlan)#exit

Enable MLD snooping on VLAN 300.

(Netgear Switch) #show mldsnooping

Admin Mode..................................... Enable

Multicast Control Frame Count.................. 0

Interfaces Enabled for MLD Snooping............ None

VLANs enabled for MLD snooping................. 300

(Netgear Switch) #