Netgear GSM7248v2 - ProSAFE 48 Port Layer 2 Gigabit L2 Ethernet Switch 管理者ガイド
482
|
Chapter 30. Captive Portal
ProSafe 7000 Managed Switch Release 8.0.3
are used to configure captive portal. VSAs are denoted in the ID column and are comma
delimited (vendor ID, attribute ID).
delimited (vendor ID, attribute ID).
Table 1. RADIUS Attributes for Configuring Captive Portal Users
RADIUS Attribute No.
Description
Range
Usage
Default
User-Name
1
User name to be authorized.
1–32 characters Required
None
User-Password
2
User password.
8–64 characters Required
None
Session-Timeout
27
Logout once session timeout is
reached (seconds). If the attribute is
0 or not present then use the value
configured for the captive portal.
reached (seconds). If the attribute is
0 or not present then use the value
configured for the captive portal.
Integer
(seconds)
(seconds)
Optional
0
Idle-Timeout
28
Log out once idle timeout is reached
(seconds). If the attribute is 0 or not
present, then use the value
configured for the captive portal.
(seconds). If the attribute is 0 or not
present, then use the value
configured for the captive portal.
Integer
(seconds)
(seconds)
Optional
0
WISPr-Max-Band
width-Up
width-Up
14122, 7
Maximum client transmit rate (b/s).
Limits the bandwidth at which the
client can send data into the network.
If the attribute is 0 or not present,
then use the value configured for the
captive portal.
Limits the bandwidth at which the
client can send data into the network.
If the attribute is 0 or not present,
then use the value configured for the
captive portal.
Integer
Optional
0
WISPr-Max-Band
width-Down
width-Down
14122, 8
Maximum client receive rate (b/s).
Limits the bandwidth at which the
client can receive data from the
network. If the attribute is 0 or not
present, then use the value
configured for the captive portal.
Limits the bandwidth at which the
client can receive data from the
network. If the attribute is 0 or not
present, then use the value
configured for the captive portal.
Integer
Optional
0
CLI: Configure RADIUS as the Verification Mode
(Netgear Switch) (Config-CP 1)#radius-auth-server Default-RADIUS-Server
(Netgear Switch) (Config-CP 1)#verification radius