Netgear GSM7248v2 - ProSAFE 48 Port Layer 2 Gigabit L2 Ethernet Switch 管理者ガイド

Set Up VLAN Routing for the VLANs and the Switch

The example is shown as CLI commands and as a Web interface procedure.

CLI: Set Up VLAN Routing for the VLANs and the Switch

The following code sequence shows how to enable routing for the VLANs:

(Netgear Switch) #vlan data

(Netgear Switch) (Vlan)#vlan routing 10

(Netgear Switch) (Vlan)#vlan routing 20

(Netgear Switch) (Vlan)#exit

This returns the logical interface IDs that will be used instead of the slot/port in 
subsequent routing commands. Assume that VLAN 10 is assigned the ID 3/1, and VLAN 
20 is assigned the ID 3/2.

Enable routing for the switch.

(Netgear Switch) #config

(Netgear Switch) (Config)#ip routing

(Netgear Switch) (Config)#exit

The next sequence shows an example of configuring the IP addresses and subnet masks 
for the virtual router ports.

(Netgear Switch) (Config)#interface vlan 10

(Netgear Switch) (Interface-vlan 10)#ip address 192.150.3.1 255.255.255.0

(Netgear Switch) (Interface-vlan 10)#exit

(Netgear Switch) (Config)#interface vlan 20

(Netgear Switch) (Interface-vlan 20)#ip address 192.150.4.1 255.255.255.0

(Netgear Switch) (Interface-vlan 20)#exit

(Netgear Switch) (Config)#exit