Netgear GSM7224v2 - 24-Port Layer 2 Managed Gigabit Switch ユーザーズマニュアル
182
|
Chapter 3. Configuring Switching Information
ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual
IGMP Snooping Querier VLAN Configuration
Use this page to configure IGMP queriers for use with VLANs on the network.
To access this page, click Switching
Multicast
IGMP Snooping
Querier VLAN
Configuration.
To configure Querier VLAN settings:
1.
To create a new VLAN ID for IGMP Snooping, select New Entry from the VLAN ID field
and complete the following fields. User can also set pre-configurable Snooping Querier
parameters.
and complete the following fields. User can also set pre-configurable Snooping Querier
parameters.
•
VLAN ID - Specifies the VLAN ID for which the IGMP Snooping Querier is to be
enabled.
•
Querier Election Participate Mode - Enable or disable Querier Participate Mode.
•
Disabled - Upon seeing another querier of the same version in the VLAN, the
snooping querier moves to the non-querier state.
•
Enabled - The snooping querier participates in querier election, in which the least
IP address operates as the querier in that VLAN. The other querier moves to
non-querier state.
IP address operates as the querier in that VLAN. The other querier moves to
non-querier state.
•
Snooping Querier VLAN Address - Specify the Snooping Querier IP Address to be
used as the source address in periodic IGMP queries sent on the specified VLAN.
2.
Click Apply to apply the new settings to the switch. Configuration changes take effect
immediately
immediately
3.
To disable Snooping Querier on a VLAN, select the VLAN ID and click Delete.
4.
Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
the latest value of the switch.
5.
Click Refresh to update the page with the latest information from the switch.