Netgear GSM7224v2 - 24-Port Layer 2 Managed Gigabit Switch ユーザーズマニュアル
228
|
Chapter 4. Routing
ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual
broadcasts will be forwarded. If you select disable they will be dropped. The default value is
disable.
disable.
8.
Use Encapsulation Type to select the link layer encapsulation type for packets transmitted
from the specified interface from the pull-down menu. The possible values are Ethernet and
SNAP. The default is Ethernet.
from the specified interface from the pull-down menu. The possible values are Ethernet and
SNAP. The default is Ethernet.
9.
Use Proxy Arp to disable or enable proxy Arp for the specified interface from the pull-down
menu.
menu.
10.
Use Local Proxy Arp to disable or enable Local Proxy ARP for the specified interface from
the pull-down menu.
the pull-down menu.
11.
Use Bandwidth to specify the configured bandwidth on this interface. This parameter
communicates the speed of the interface to higher level protocols. OSPF uses bandwidth to
compute link cost. Valid range is (1 to 10000000).
communicates the speed of the interface to higher level protocols. OSPF uses bandwidth to
compute link cost. Valid range is (1 to 10000000).
12.
Use ICMP Destination Unreachables to specify the Mode of Sending ICMP Destination
Unreachables on this interface. If this is Disabled then this interface will not send ICMP
Destination Unreachables. By default Destination Unreachables mode is enable.
Unreachables on this interface. If this is Disabled then this interface will not send ICMP
Destination Unreachables. By default Destination Unreachables mode is enable.
13.
Use ICMP Redirects to enable/disable ICMP Redirects Mode. The router sends an ICMP
Redirect on an interface only if Redirects are enabled both globally and on the interface. By
default ICMP Redirects Mode is enable.
Redirect on an interface only if Redirects are enabled both globally and on the interface. By
default ICMP Redirects Mode is enable.
14.
Use IP MTU to specify the maximum size of IP packets sent on an interface. Valid range is
68 bytes to the link MTU. Default value is 0. A value of 0 indicates that the IP MTU is
unconfigured. When the IP MTU is unconfigured the router uses the link MTU as the IP
MTU. The link MTU is the maximum frame size minus the length of the layer 2 header.
68 bytes to the link MTU. Default value is 0. A value of 0 indicates that the IP MTU is
unconfigured. When the IP MTU is unconfigured the router uses the link MTU as the IP
MTU. The link MTU is the maximum frame size minus the length of the layer 2 header.
Table 11.
Field
Description
VLAN ID
Displays the VLAN ID for the interface.
Link State
The state of the specified interface is either Active or
Inactive. An interface is considered active if it the link
is up and it is in forwarding state.
Inactive. An interface is considered active if it the link
is up and it is in forwarding state.
OSPF Admin Mode
Displays OSPF admin mode of the interface. The
default value is disable.
default value is disable.
Click DELETE to delete the IP Address from the selected interface.
Click REFRESH to refresh the web page to show the latest IP information.