Netgear GSM7224v2 - 24-Port Layer 2 Managed Gigabit Switch ユーザーズマニュアル
Chapter 4. Routing
|
237
ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual
IPv6 Prefix Configuration
To display the IPv6 Prefix Configuration page, click Routing
IPv6
Advanced
Prefix
Configuration.
1.
Use Interface to select the interface to be configured. When the selection is changed, a
screen refresh will occur causing all fields to be updated for the newly selected port. All
physical interfaces are valid.
screen refresh will occur causing all fields to be updated for the newly selected port. All
physical interfaces are valid.
2.
Use IPv6 Prefix/Prefix Length to specify the IPv6 prefix with prefix length for an interface.
3.
Use EUI-64 to specify 64 bit unicast prefix.
4.
Use Valid Lifetime to specify router advertisement per prefix time to consider prefix valid for
purposes of on link determination. Valid lifetime must be in the range 0 to 4294967295.
purposes of on link determination. Valid lifetime must be in the range 0 to 4294967295.
5.
Use Preferred Lifetime to specify router advertisement per prefix time. An auto configured
address generated from this prefix is preferred. Preferred lifetime must be in range 0 to
4294967295.
address generated from this prefix is preferred. Preferred lifetime must be in range 0 to
4294967295.
6.
Use OnLink Flag to specify selected prefix can be used for on-link determination. Default
value is enable. This selector lists the two options for on-link flag: enable and disable.
value is enable. This selector lists the two options for on-link flag: enable and disable.
7.
Use Autonomous Flag to specify selected prefix can be used for autonomous address
configuration. Default value is disable. This selector lists the two options for autonomous
flag: enable and disable.
configuration. Default value is disable. This selector lists the two options for autonomous
flag: enable and disable.
Table 15.
Field
Description
Current State
Indicates the state of the IPV6 address. The state is
TENT if routing is disabled or DAD fails. The state is
Active if interface is active and DAD is successful.
TENT if routing is disabled or DAD fails. The state is
Active if interface is active and DAD is successful.
•
Click ADD to add a new IPv6 address to the interface.
•
Click DELETE to delete a existing IPv6 address entry from the interface.