Netgear FS752TPS – ProSAFE 48 Port 10/100 Stackable Smart Switch with 4 Gigabit Ports and 24 Port PoE ハードウェアマニュアル

iii

This section includes user requirements for operating this product in accordance with National laws for usage of radio 
spectrum and operation of radio devices. Failure of the end-user to comply with the applicable requirements may result 
in unlawful operation and adverse action against the end-user by the applicable National regulatory authority.

NOTE: This product's firmware limits operation to only the channels allowed in a particular Region or Country.  

Therefore, all options described in this user's guide may not be available in your version of the product.

Marking by the above symbol indicates compliance with the Essential Requirements of the R&TTE Directive of the 
following EU Council Directives: 89/336/EEC and LVD 73/23/EEC. Compliance is verified by testing to the following 
standards: EN55022 Class A, EN55024 and EN60950-1.

EN300 328, EN301 489-17, EN60950

This product does not contain any user serviceable components and is to be used with approved antennas only. Any 
product changes or modifications will invalidate all applicable regulatory certifications and approvals

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment 
should be installed and operated with minimum distance of 20 cm between the radiator and your body. 

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. 

We NETGEAR, Inc., 4500 Great America Parkway, Santa Clara, CA 95054, declare under our sole responsibility that 
the model 

FS700TS Smart Switch with Gigabit Ports

 complies with Part 15 of FCC Rules. Operation is subject 

to the following two conditions:

•

This device may not cause harmful interference, and

•

This device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of 
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential 
installation. This equipment uses and can radiate radio frequency energy and, if not installed and used in accordance 
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that 
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or 
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to 
correct the interference by one or more of the following methods:

•

Reorient or relocate the receiving antenna

•

Increase the separation between the equipment and the receiver