Netgear M4100-D12G (GSM5212v1h1) - 10‐port GE + 2 GE Combo L2 Managed PD Switch ソフトウェアガイド

This output is for the network port:

(NETGEAR Switch) #show network

 

Interface Status............................... Always Up

IP Address..................................... 10.250.3.1

Subnet Mask.................................... 255.255.255.0

Default Gateway................................ 10.250.3.3

IPv6 Administrative Mode....................... Enabled

IPv6 Address/Length is ........................ FE80::210:18FF:FE82:337/64

IPv6 Address/Length is ........................ 3099::1/64

IPv6 Address/Length is ........................ 3099::210:18FF:FE82:337/64

IPv6 Default Router is ........................ FE80::204:76FF:FE73:423A

Burned In MAC Address.......................... 00:10:18:82:03:37

Locally Administered MAC Address............... 00:00:00:00:00:00

MAC Address Type............................... Burned In

Network Configuration Protocol Current......... None

Management VLAN ID............................. 1

Web Mode....................................... Enable

Java Mode...................................... Enable

This section describes the commands you use to configure the console port. You can use a 
serial cable to connect a management host directly to the console port of the switch.

Use this command to access Global Config mode. From Global Config mode, you can 
configure various system settings, including user accounts. You can also enter other 
command modes, including Line Config mode.

Use this command to access Line Config mode, which allows you to configure various Telnet 
settings, ssh settings, and the console port. 

Format

configuration

Mode

Privileged EXEC

Format

line {console | telnet | ssh}

Mode

Global Config