Netgear M4300-28G (GSM4328S) - Stackable Managed Switch with 24x1G and 4x10G including 2x10GBASE-T and 2xSFP+ Layer 3 管理者ガイド
DiffServ
258
Managed Switches
Example 2: Change the Queue of Protocol-Based Auto VoIP
This example is provided as CLI commands and as a web interface procedure.
CLI: Change the Queue of Protocol-Based Auto VoIP
Protocol-based VoIP classifies and prioritizes packets and places them in the higher-priority
queue. By default, the packets are placed in egress queue 6. However, you can override the
egress queue setting. The following example shows how to assign the protocol-based Auto
VoIP to egress queue 4.
queue. By default, the packets are placed in egress queue 6. However, you can override the
egress queue setting. The following example shows how to assign the protocol-based Auto
VoIP to egress queue 4.
1.
Change the egress queue of protocol-based Auto VoIP.
2.
Display the Auto VoIP information.
Web Interface: Configure Protocol-Based Auto VoIP
1.
Change the queue of protocol-based Auto VoIP.
a. Select Switching > Auto-VoIP > Protocol-based > Port Settings.
A screen similar to the following displays.
b. From the Class Value menu, select 4.
c. Click Apply.
(Netgear Switch) (Config)#auto-voip protocol-based traffic-class 4
(Netgear Switch) #show auto-voip protocol-based interface 2/0/1
VoIP VLAN Id................................... 2
Prioritization Type............................ traffic-class
Class Value.................................... 4
Interface Auto VoIP Mode Operational Status
--------- -------------- -----------------
2/0/1 Enabled Up