Netgear M4100-26-POE (FSM7226Pv1h1) - 24‐port FE + 2 GE Combo L2 Managed PoE Switch ソフトウェアガイド

This command displays a summary of policy-oriented statistics information for all interfaces 
in the specified direction. 

The information that is shown in the following table is repeated for each interface and 
direction (only those interfaces configured with an attached policy are shown).

This section describes the commands you use to configure MAC ACL settings. MAC ACLs 
ensure that only authorized users have access to specific resources and block any 
unwarranted attempts to reach network resources. 

The following rules apply to MAC ACLs:

The maximum number of ACLs you can create is hardware-dependent. The limit applies 
to all ACLs, regardless of type.

The system supports only Ethernet II frame types.

The maximum number of rules per MAC ACL is hardware-dependent.

This command creates a MAC access control list (ACL) identified by <name>, consisting of 
classification fields defined for the Layer 2 header of an Ethernet frame. The <name> 
parameter is a case-sensitive alphanumeric string from 1 to 31 characters uniquely 
identifying the MAC access list.

If a MAC ACL by this name exists, this command enters Mac-Access-List config mode to 
allow updating the existing MAC ACL.

The CLI mode changes to Mac-Access-List Config mode when you 
successfully execute this command.

Format

show service-policy {in | out}

Mode

Privileged EXEC

Interface

Valid slot and port number separated by forward slashes.

Operational 
Status

The current operational status of this DiffServ service interface.

Policy Name

The name of the policy attached to the interface.