Netgear MBR1200 - HSPA+ Mobile Broadband Wireless Router ユーザーズマニュアル

Go back to the router screen to check for a message.

The router WPS screen displays a 
message confirming that the client was 
added to the wireless network. The router 
generates an SSID, and implements 
WPA/WPA2 wireless security. The router 
will keep these wireless settings unless 
you change them, or you clear the Keep 
Existing Wireless Settings

 check box in 

the Advanced Wireless Settings/WPS 
Settings screen.

Note the new SSID and WPA/WPA2 

password for the wireless network. You can 

view these settings in the Wireless Settings 

screen. See 

on page 27.

To access the Internet from any computer connected to your router, launch a browser such 
as Microsoft Internet Explorer or Mozilla Firefox. You should see the router’s Internet LED 
blink, indicating communication to the ISP.

If no WPS-capable client devices are located during the 2-minute 

time frame, the SSID does not change, and no security is set up.

WPS PIN Entry

Any wireless computer or device that will connect to the router wirelessly is a client. The 
client must support a WPS PIN, and must have a WPS configuration utility, such as the 
NETGEAR Smart Wizard or Atheros Jumpstart.

The first time you add a WPS client, make sure that the Keep Existing Wireless Settings 
check box on the WPS Settings screen is cleared. This is the default setting for the router, 
and allows it to generate the SSID and WPA/WPA2 security settings when it implements 
WPS. After WPS is implemented, the router automatically selects this check box so that your 
SSID and wireless security settings stay the same if other WPS devices are added later.

Log in to the router as described in