Netgear WG511v1 - 54 Mbps Wireless PC Card 32-bit CardBus 参照マニュアル
Installation Guide for the NETGEAR 54 Mbps Wireless PC Card WG511
3-30
Configuration
How to Configure WEP Encryption Security
Following the steps below to perform this procedure.
connecting to an access point.
1. Run the WG511 Configuration Utility.
a.
Make sure the WG511 software is installed and the WG511 is fully inserted in an available
CardBus slot in your PC.
CardBus slot in your PC.
b.
Open the configuration utility by clicking on the WG511 icon
in the Windows
system tray.
Figure 3-7: Security tab page
c.
Click on the Configuration tab to display the view shown above.
2. Configure the Security settings.
a.
Check the Enable Encryption check box.