Netgear WNR2200 - N300 Wireless Router ユーザーズマニュアル
N300 Wireless Router with USB WNR2200 User Manual
Safeguarding Your Network
2-17
v1.0, September 2010
Connecting Additional Wireless Client Devices After WPS
Setup
Setup
You can add more WPS clients to your wireless network, or you can add a combination of WPS-
enabled clients and clients without WPS.
enabled clients and clients without WPS.
Adding More WPS Clients
To add a wireless client device that is WPS-enabled:
2. To view a list of all devices connected to your wireless router (including wireless and
Adding Both WPS and Non-WPS Clients
For non-WPS clients, you cannot use the WPS setup procedures to add them to the wireless
network. You must record, and then manually enter your security settings (see
network. You must record, and then manually enter your security settings (see
).
To connect a combination of non-WPS enabled and WPS-Enabled clients to the wireless router:
1. Restore the wireless router to its factory default settings (press and hold the Reset button on
the back of the router for 5 seconds).
When the factory settings are restored, all existing wireless clients are disassociated and
disconnected from the wireless router.
disconnected from the wireless router.
2. Configure the network names (SSIDs), select the WPA/PSK + WPA2/PSK radio button on the
Wireless Settings screen (see
and click Apply. On the WPA/PSK + WPA2/PSK screen, select a passphrase and click Apply.
Record this information to add additional clients.
Record this information to add additional clients.
Note: Your wireless settings remain the same when you add another WPS-enabled client,
as long as the Keep Existing Wireless Settings check box is selected in the
Advanced Wireless screen (listed under the Advanced heading in the wireless
router main menu). If you clear this check box, when you add the client, a new
SSID and passphrase will be generated, and all existing connected wireless clients
will be disassociated and disconnected from the wireless router.
Advanced Wireless screen (listed under the Advanced heading in the wireless
router main menu). If you clear this check box, when you add the client, a new
SSID and passphrase will be generated, and all existing connected wireless clients
will be disassociated and disconnected from the wireless router.