Netgear WGX102v2 - 54 Mbps Wall-Plugged Wireless Range Extender 参照マニュアル

Troubleshooting

8-5

Most TCP/IP terminal devices and routers contain a ping utility that sends an echo request packet 
to the designated device. The device then responds with an echo reply. Troubleshooting a TCP/IP 
network is made very easy by using the ping utility in your computer or workstation.

You can ping the wireless range extender from your computer to verify that the LAN path to your 
wireless range extender is set up correctly.

To ping the wireless range extender from a PC running Windows 95 or later:

1. From the Windows toolbar, click the Start button and select Run.

2. In the field provided, type Ping followed by the IP address of the WGX102, as in this example:

3. Click OK.

You should see a message like this one:

If the path is working, you see this message:

If the path is not working, you see this message:

If the path is not functioning correctly, you could have one of the following problems:

•

Wrong physical connections

— Make sure the Wireless port LED is lit.

— Check that the Link LEDs are on for your network interface card.

— Using the Wireless configuration utility provided with your wireless client card, make 

sure the SSID of your client card is the same as the WGX102. The default is 
NETGEAR.

— Make sure the security settings of your client card are the same as the WGX102. The 

default is to have WEP and WPA-PSK disabled.