Netgear WGX102v2 - 54 Mbps Wall-Plugged Wireless Range Extender 参照マニュアル

6-10

Maintenance

It is sometimes desirable to restore the wireless range extender to the original default settings. The 
Erase function restores all factory settings. After an erase, the wireless range extender's password 
is password and the LAN IP address is 192.168.0.101.

To erase the configuration, click and hold the reset button for at least 15 seconds. 

Do not turn off the power to the WGX102 until the power LED has turned solid green.

To restore the factory default configuration settings without knowing the login password or IP 
address, you must use the default reset button on the bottom panel of the WGX102. See 

The software of the Wireless Range Extender is stored in FLASH memory, and can be upgraded as 
new software is released by NETGEAR. Upgrade files can be downloaded from the NETGEAR 
Web site. If the upgrade file is compressed (.ZIP file), you must first extract the file before sending 
it to the wireless range extender. The upgrade file can be sent to the router using your browser. 

Note: The Web browser used to upload new firmware into the Wireless Range Extender must 
support HTTP uploads. NETGEAR recommends using Microsoft Internet Explorer or Netscape 
Navigator 3.0 or above. 

From the main menu of the browser interface, under the Maintenance heading, select Upgrade 
Firmware to display the menu shown below. 

Note: Before upgrading the WGX102 software, use the Backup Settings menu to save 
your configuration settings. Any wireless range extender upgrade reverts the WGX102 
settings back to the factory defaults. After completing the upgrade, you can restore your 
settings from the backup.