Netgear PR2000 - Trek N300 Travel Router and Range Extender ユーザーズマニュアル

Connect or reset your Trek.

Connect or reset your Trek using the following items:

Reset button. To reset the Trek to its factory settings, insert a paper clip into the Reset 
hole and hold it until the Internet LED blinks. See 

143 for 

information about restoring factory settings.

Internet/LAN port. When the Internet via switch is set to Wired, this port becomes an 
Internet port. When the switch is set to Wireless, this port becomes a LAN port for any 
Ethernet-enabled device.

LAN port. A LAN port for any Ethernet-enabled device.

USB port. A USB port for USB storage or a USB printer. When the Trek is plugged into 
the wall, the USB port can also be used as a cell phone charger.

WiFi LED

Green. Either the LAN port or a wireless device is connected to the Trek.

Off. No device is connected.

USB LED

Green. The USB drive is properly mounted.

Off. No USB drive is detected.