Netgear PR2000 - Trek N300 Travel Router and Range Extender ユーザーズマニュアル

When power is first applied, verify that the Power LED is lit.

After approximately 30 seconds, verify the following:

The Power LED is solid green.

The Internet LED is lit.

If using WiFi, the WiFi LED is lit.

You can use the Trek’s LEDs for troubleshooting.

Make sure that the power cord is securely connected to your Trek and that the power adapter 
is securely connected to a functioning power outlet. 

Make sure that you are using the 12 VDC, 2.5A power adapter that NETGEAR supplied for 
this product.

When the Trek is turned on, the LEDs light for about 10 seconds and then turn off. If all the 
LEDs stay lit, the fault is within the Trek.

If all LEDs are still lit one minute after power-up, do the following:

Cycle the power to see if the Trek recovers.

Press and hold the Reset button to return the Trek to its factory settings. See 

143.

If the error persists, you might have a hardware problem. Contact technical support at 

.

If the Internet LED does not light when the Ethernet connection is made, check the following:

Make sure that the Ethernet cable connections are secure at the Trek and at the modem 
or computer.

Make sure that power is turned on to the connected modem or computer.

Be sure that you are using the correct cable:

When connecting the Trek’s Internet port to a cable or DSL modem, use the cable that 
was supplied with the cable or DSL modem. This cable could be a standard 
straight-through Ethernet cable or an Ethernet crossover cable.