Netgear WG511v2 - 54 Mbps Wireless PC Card 32-bit CardBus ユーザーズマニュアル

Basic Setup

3-3

Your NETGEAR 54 Mbps Wireless PC Card WG511v2 factory default basic settings are: 

•

Network Name Service Set Identification (SSID): Any (First available network)

•

Network Mode (Infrastructure or Ad-hoc): Infrastructure

•

Data security WEP or WPA-PSK encryption: Disabled

The section below provides instructions for setting up the NETGEAR 54 Mbps Wireless PC Card 
WG511v2 for basic wireless connectivity to an access point. The procedures below provide step-
by-step installation instructions for Windows PCs. Use the procedure that corresponds to the 
version of Windows that you are using.

Use the procedure below that corresponds to the version of Windows you are using.

1. First, install the WG511v2 software.

Note: In order for the WG511v2 Wireless PC Card to communicate with a wireless 

access point or wireless adapter, all devices must be set up to use the same 
wireless network name (SSID).

a.

Insert the NETGEAR CD.

If the CD 

main page does not appear, double click 
autorun.exe on the CD.

b. Click the Install Software link and the 

Smart Wizard starts. 

c.

Follow the Wizard steps, and click Next 
to continue. 

d. When the Installation Complete 

message appears, click Next.